Safety requirements for electronic product design
I believe everyone should know that electronic product design is not a simple matter. Although it seems relatively simple in the eyes of others, in the actual design process, it involves a lot of things. Therefore, in order to ensure the smooth progress of the entire electronic product design, we must not only know the product use environment and users, but also consider the safety requirements of electronic product design before designing. So what are the safety requirements for electronic product design? The following editor of Zhixinqiang Technology will introduce you:
Safety requirements for electronic product design:
1. Electric shock prevention:
The protection of electronic products and equipment from electric shock is the minimum requirement for all electrical equipment. For this reason, any electronic product design must have adequate measures to prevent electric shock.
2, energy hazard prevention:The high-current output terminal is short-circuited, which can cause ignition, melting of metal, and fire, so low-voltage circuits can also be dangerous.
3, fire prevention:
The grid materials of electronic products we use generally use fuel-resistant materials. After a fire, there is less smoke and less poisonous gas as the outer shell. In the event of an accidental fire alarm, there will be no secondary fire, and the small smoke does not affect the escape of the staff. , The chance of poisoning is small.
Any exposed parts are generally for heat dissipation, so its temperature must be considered. Excessive temperature may cause burns to users.
5. Prevent mechanical hazards:There are also some moving parts in electrical products, such as the blades of electric fans, which may cause harm to users. In addition, it is the outer shell of the product. The joint must not have a knife-edge shape. The center of gravity of the product and the components of high vacuum are all electronic product designers must consider.
6. Radiation protection:
Radiation is divided into four categories, one is audio radiation, the other is radio frequency radiation, the third is optical radiation, and the fourth is ionizing radiation. The users of electronic products are completely unaware of radiation, and it is entirely up to the designers of electronic products to consider things seriously when designing.
The content introduced above is the safety requirements of electronic product design. Of course, in the process of electronic product design, in addition to safety requirements, we should pay attention to other aspects. Only in this way can we better ensure the smooth progress of electronic product design.
The dilemma facing the PCB design industry
Since my country’s electronics industry is mainly distribut...
Design steps of PCB design
In the PCB, special components refer to the key components o...
Analysis of the status quo of the analog chip industry
In 2019, the global integrated circuit industry market size ...
Chip packaging and testing: mature areas in the local semiconductor industry chain
It is reported that Huawei and ZTE are intentionally moving ...
24-hour service phones+86-18902849076
—— WeChat communication